SATA Bridge Board

IDE-SATA07

Parallel ATA to Serial ATA Host Mode Bridge Board featuring Marvell 88SA8052 Bridge Controller

Parallel ATA to Serial ATA Host Mode Bridge Board featuring Marvell 88SA8052 Bridge Controller
Introduction

IDE-SATA07 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring Marvell 88SA8052 Serial ATA bridge Controller.

IDE-SATA07 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.


Technical Specification

Parallel ATA to Serial ATA Bridge Board:

  • Serial ATA:
    • Compliant with Serial ATA 1.0
    • 48-bit sector addressing
  • Serial ATA Connector:
    • Signal + Power (7+15 pin) Female Type Connector
  • Parallel ATA:
    • Ultra ATA/133 Parallel Interface
    • 48-bit sector addressing
    • Jumper for selecting Mater and Slave
  • Parallel ATA Connector:
    • Male IDC 2X20 pin Connector
  • Transfer Rate:
    • Supports PIO and DMA modes
    • Supports bus master DMA at 1.5Gbps burst rate
  • DC Power Connector:
    • IDE Big 4-pin power connector
  • LEDs
    • Power LED
    • SATA PHY Ready LED
    • Activity LED (Pin Header 2pin Pitch=2.54mm)

Physical Dimensions
  • 2.3 " x 1.00" (5.85cm x 2.54cm)
  • Direct Connect Vertical type

Kit includes
  • IDE-SATA07 Bridge Board
  • User's Manual

Packing list

under construction

Q'ty Carton size(cm) N.W. G.W. Remark
200 58*44*23cm 3 5.5 CT0008


Document Download
Specifications subject to change without prior notice