IOI Technology Corporation
Your I/O Solution Provider

IDE-SATA20 is a Parallel ATA to Serial ATA Host mode Bridge Board featuring JMicron JM20330APC0 Serial ATA bridge Controller.

IDE-SATA20 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.

Parallel ATA to Serial ATA Bridge Board:

• Serial ATA:
  • Compliant with Serial ATA 1.0
  • 48-bit sector addressing
• Serial ATA Connector:
  • Signal + Power Female Type Connector
• Parallel ATA:
  • Ultra ATA/133 Parallel Interface
  • 48-bit sector addressing
  • Jumper for selecting Mater and Slave
• Parallel ATA Connector:
  • Male IDC 2X20 pin Connector
• Transfer Rate:
  • Supports PIO and DMA modes
  • Supports bus master DMA at 1.5Gbps burst rate
• DC Power Connector:
  • Mini 4-pin floppy type power connector

• 2.55 " x 1.00" (6.5cm x 2.54cm)
• Direct Connect Vertical type

• IDE-SATA20 Bridge Board
• User's Manual

under construction