IOI Technology Corporation
Your I/O Solution Provider

IDE-SATA10 is a Parallel ATA to Serial ATA Hostmode Bridge Board (1.5Gbps) featuring SunPlus SPIF223A Serial ATA Controller.
IDE-SATA10 is ideally suited for tailgate interface applications for converting Serial ATA device into ATA device. Both ATA and ATAPI modes are supported using the same firmware.

Parallel ATA to Serial ATA Bridge Board:

• Serial ATA:
  • Compliant with Serial ATA 1.0a specification
  • Support Serial ATA Generation 1 transfer rate of 1.5Gb/s.
  • Support Serial ATA power saving mode: Partial, and Slumber..
• Serial ATA Connector:
  • Signal + Power Female Type Connector
• Parallel ATA:
  • Compliant with ATA specification
  • Compliant with Ultra ATA/133
  • Support PIO mode 0, 1, 2, 3, 4
  • Support Multiword DMA mode 0, 1, 2
  • Support Ultra DMA mode 0, 1, 2, 3, 4, 5, 6
  • Support ATA and ATAPI device like HDD, ODD and Tape..
  • Jumper for selecting Mater and Slave
• Parallel ATA Connector:
  • Male IDC 2X20 pin Connector
• DC Power Connector:
  • Mini 4-pin floppy disk drive like power connector

• 3.97" x 1.00" (10.09cm x 2.54cm)
• Direct Connect Vertical type

• IDE-SATA10 Bridge Board
• Big 4pin to floppy drive like Mini 4-pin DC Power Cable (Red, Black, & Yellow)
• User's Manual
• 1-WARRANTY Card

under construction

Q'ty	Carton size(cm)	N.W.	G.W.	Remark
NA	65x40.8x28.5	NA	NA	CT0001
NA	53.5x34x29	NA	NA	CT0009